≤ 6300A – 100KA

CE-PC “Power Center” switchboards are designed for use in any installation where electric energy is produced, transformed and distribuited. In addition they can be used for the protection and handling of electrical users of up to 600 V a.c. and 600 V d.c.

GENERAL CHARACTERISTICS

The supporting framework of the switchboard is modular and made of rectangular C-shaped open-ended galvanizaded steel section, with standard perforations. This framework can be hold fixings for metal segregations, bar-holding panels and moorings for incoming and outgoing cables.The front part of the switchboard contains and controls the switches whilst in the rear the copper distribution bars can be found togheter with the cable’s starting point and storage.

Protection against fire is insured by the use of self-extinguishing materials and internal metal panels

VERSIONS

Switchboards can be supplied in the following versions:

  • PC 200 N Non segerated: main bus bars and shunt bus bars are visible after removing or opening rear panel. Bus bars are in any case separated from operational units. This version allows to install several switches in one compartement.
  • PC 200 P Partially segregated: main bus bars, shunt bus bars and circuit breaker feeder connection are separated by metal panels.
  • PC 200 S Fully segregated: all areas are separated from each other. This enables maximum continuity of service whilst maintenance is carried out. Maximum safety guaranteed during access to power cables area of each circuit-breaker wile switchboard is live.
  • Front and rear access
  • For indoor installation, normal degree of protection:
    – IP 30 on outside case
    – IP 20 inside the switchboard
  • Protection up to IP55 is available for specific polluted environments with presence of dust and liquids.
  • For special environments and temperatures

DOWNLAOD TECHNICAL SHEET (PDF)

Other info

ELECTRICAL DATA
Rated Voltage

660 V
Rated insulating voltage up to

1000 V
Rated frequency

50/60 Hz
Rated current up to

6300 A
Maximum short-term rated current (1 sec.) up to

100 kA
Maximum peak current up to

230 kA
Internal Arc Withstanding current IAC-FLR (0,5 sec)**

100 kA
** Internal arc withstanding in option
STANDARDS AND TESTS

The CE-PC200 series complies with the main Italian and International standards, and in particular with:

  • IEC 61439-1
  • IEC 61439-2
  • IEC 61641
  • DPR 547

All switchboards have passed the relevant tests carried out by qualified laboratories.